Valor Fires 842 Instrukcja Użytkownika Pobierz pdf (Strona 26)

INSTALLER GUIDE

Page 26

6. Thread the cables through the eyebolts. Return the

cables through the holes near the bottom of the

convection box back panel (See figure 21).

7. Place the convection box fully back into the fireplace

opening so that it is sealed against the fireplace front

surround.

8. Drill a hole into the fireplace floor through each of the

two holes in the base of the convection box using a

suitably sized masonry drill for the fibre / wooden plugs

supplied (See figure 22).

9. Insert a fibre / wooden plug into each hole. Use the

fibre / wooden plugs supplied with this appliance - Never

use plastic plugs instead of the fibre / wooden plugs

supplied. Fit a woodscrew in each plug and tighten.

Always screw the base into position

before applying tension to the cables.

This will ensure a tight seal between the

top of the convection box and wall.

10. Fit a cable retainer over the bottom end

of each cable.

Figure 22. Floor fixing

Figure 21. Cable route

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Brak uwag

Valor Fires 842 Instrukcja Użytkownika Strona 26